Service manual

3-52 Tire Pressure Monitoring Suspension
2006 LSSV Service Manual Supplement
5. A new transmitter identification can be learned in two
ways:
• Vigorously shake the transmitter to provoke a
transmission.
• By inflating or deflating the tire by more than 0.2
Bar (3 psi).
6. To remove the transmitter from the selected tire location,
press the MODE button.
Important: To prevent the last identification from being erased,
scroll to the next tire position before driving. A beep and rapid
flashing of the alarm light indicate a transmission was received.
The new ID is stored.
7. Press the TIRE button to scroll to another position and
repeat step 4 or 5 as required.
8. Press the SET button to save and exit.
If no error is found, the system will reset and go to normal mode.
If more than one tire location contains the same sensor ID, the
display will prompt an error and flash between this message and
the display, with the conflicting tires filled in. If so indicated
repeat the programming procedure above.
Learn Procedure with Initiator
Tools Required
090.0006 Programming Initiator
Learn Mode Description
Important: To ensure proper operation, the Programming
Initiator must be held facing the sensor for at least 5 seconds
after the appropriate button is pressed. Sensors are normally
located next to the valve. Hold the initiator against the tire and
point it towards the sensor from a position slightly outside the rim
flange.