Service manual

Suspension Tire Pressure Monitoring 3-53
2006 LSSV Service Manual Supplement
The receiver that is installed on the vehicles needs to have a
unique sensor identification code for each wheel position
programmed into it to ensure proper orientation of the system.
Each wheel assembly has a sensor in it that can be activated
using the initiator. When the sensor is activated, it sends out its
unique identification code, which is then stored in the memory of
the receiver so that it knows which sensors belong to that
vehicle. The vehicle does not have to be moving to accomplish
this task, which allows programming of receivers to be carried
out very easily.
Learn Mode Calibration
1. Turn ON the ignition, with the engine OFF.
2. Apply the parking brake.
Important: Install the sensors on the wheels. Refer to Tire
Pressure Monitor Sensor Replacement. If sensors are already
installed on the vehicle, make sure the vehicle is stationary for
20 minutes before proceeding to step 3.
3. Turn ON the initiator, ensure the LED is green.
4. Enter Level 2 Programming Mode. Refer to Tire Pressure
Monitoring Sensor Programming.
5. Press the MODE button to select learn mode, which is
indicated by a head with a question mark icon.
6. Press the TIRE button to display the possible wheel
positions for the towing vehicle (a windshield can also be
seen to indicate that the towing vehicle is selected). The
outline of the wheel position to be programmed will flash.
If a sensor already exists in this position (the tire icon is
filled in), it is recommended to remove the sensor by
pressing the MODE button.