Service manual

3-54 Tire Pressure Monitoring Suspension
2006 LSSV Service Manual Supplement
7. Determine the actual sensor location (normally located
adjacent to the valve stem) on the wheel to be
programmed. Position the initiator (1) against the tire’s
sidewall for that sensor location, press the LEARN button
and hold the unit steady for at least 5 seconds. The
flashing wheel icon on the gage display will become filled
in when the sensor ID has been successfully captured by
the receiver. (If this does not occur, repeat step 7.)
Important: Waiting too long to select the next tire position or
exiting the LEARN mode increases the likelihood of inadvertently
overwriting the recently learned sensor by receiving signals from
other sensors installed on the vehicle or from other vehicles in
close proximity.
8. If programming more sensors into the system,
immediately select the next tire position on the gage
display and repeat step 8 until all sensor ID numbers and
their appropriate positions have been learned by the
receiver.
Important: If an error message is displayed together with
flashing tire positions, those indicated positions have been
programmed with the same sensor ID numbers. In this case,
press the TIRE button on the system switch panel to re-enter the
receiver LEARN mode and reprogram the sensor positions that
were flashing.
9. Immediately exit the receiver LEARN mode by pressing
the SET button on the system switch panel.
Verifying Correct Sensor Position
1. Turn ON the ignition, with the engine OFF.
2. Apply the parking brake.
3. Place the initiator next to each sensor position but this
time press the INITIATE button to cause each sensor to
transmit ID number and tire data to drive the vehicle
above 6 mph.
4. If the correct tire sensor positions are not being received.
Refer to Learn Procedure with Initiator.