Service manual

Driveline/Axle Transfer Case - NVG 261-NP2 4-7
2006 LSSV Service Manual Supplement
Transfer Case - NVG 261-NP2
Repair Instructions
Transfer Case Vent Tube Filter
Replacement
Removal Procedure
Caution: Refer to Vehicle Lifting Caution in Cautions and
Notices.
Important: The filter is located on the left side of the vehicle.
1. Raise the vehicle. Refer to Lifting and Jacking the
Vehicle in General Information in 2006 C/K Truck Service
Manual.
2. Install safety stands.
3. Remove the clamps (2) holding the filter (1) to the hoses.
4. Remove the filter and discard.
Installation Procedure
Important: The filter arrow must point toward the transfer case.
If replacing the hose, the length of the new hose must match the
length of the old hose.
1. Install the filter (1) to the hoses.
2. Install hose clamps (2) and hand tighten.
3. Remove the safety stands.
4. Lower the vehicle. Refer to Lifting and Jacking the
Vehicle in General Information in 2006 C/K Truck Service
Manual.