Manual

VIDEOSETUPMENU:

PresstheSETUPbuttontoenterthemenu,seHectVHDEOSETUPusingtheNavigation

(4,_) buttons,thenpressthePLAY/ENTERbuttonontheremote(ENTERbuttononmain

unit)toselectit.SeHect/changethesetupoptionasdescribedonthisandthefollowingpage

usingtheNavigation(4,_,-,&, T ) buttons and the PLAY/ENTER button.

COMPONENT SHARPNESS

iiComponent

LCD: Select to see [he image on the built-in screen. (You

can connect to an external TV to see the image using the

Video cable.)

YUV: Select for Component (Y/PB/PR or Y/CB/CR)

Output. (You will need to connect to an external TV to see

the image using the Component cable.)

NOTE: When you select YUV, the builtqn screen will turn

off automatically and you can see the image on the

external TV using the Component cable. "Tb see the

image on the builbin screen again, turn off the unit and

then turn on again, the Component Output will reset to

LCD.

TV MODE

The TV Mode setting is for Component Output only. Once

you have set Component Out to YUV, you can select the

"Pv_Mode setting:

P-Scan: Select for Progressive Scan Component Video

Output.

Interlace: If you connect a TV (using the Component

Cable) that is not compatible with a progressive scan

signal, select Interlace for the Component Video Output.

Adjust for the desired sharpness (HIGH,

MEDIUM, LOW).

BRIGHTNESS

Brightness

CONTRAST

Adjust to sharpen or soften the picture.

Contrast

Adjust to increase or decrease the contrasL