Manualshelf

Owner's Manual

ManualsBrandsMemphis Audio ManualsCar Audio & VideoMemphis Audio 16-MXALEDBT
123
R.G.B
(RED.
GREEN.
BLUE}
CHART
Smartphone Controlled
LEO
Accent Kit
When
in Fade/Music sync mode you
can
choose a solid color or allow
the
lights
to
scroll through a
series
of
colors.
The
RGB
values in these modes
will
determine
if
the
light
colors
will
remain solid
or scroll through multi colors. Please refer
to
the
following chart
for
color settings.
OPTIONAL
3-
BUTTON
WIREO
REMOTE
An
optional 3-button wired remote is included
with
your smartphone kits.
To
install
the
wired
remote, connect the harness
to
the
open connection
on
the
main harness.
Run
the
optional wired
remote button
to
a convenient location and mount
it
firmly
onto your bike.
You
can
now control
your
LED
kit
in
the
absence
of
your Bluetooth device.
WIRED
REMOTE
OPERATING
INSTRUCTIONS
Press/release
the
power button
to
turn
on
your lighting system. Press
and
hold
the
power button
to
turn
off
the
lighting system.
Press/release
the
power button
to
scroll color modes through Solid Color/Flash/Loop/Fade
SOLID
COLOR
MODE:
Press
the button
up
or
down to scroll between 15 preset colors.
FLASH
MODE:
Press/Release
up
or down
to
select
one
of
15
preset colors. Press and hold
the
button up or down
to
increase or decrease
the
pattern speed.
FADE
MODE:
Press/release the button
up
or down
to
scroll between 7 preset colors. Press
and
hold
the button
up
or down the increase or decrease the pattern speed.
LOOP
MODE:
Press and hold
the
button up or down
to
increase or decrease
the
pattern speed.
At
any
point
users
can
take control
of
their
device
with
their
Smartphone
MEMPHIS
iLED
app.
The
smartphone app
will
override
the
manual wired remote control button.
OPERATING
RANGE
Operating range
for
this
and other Bluetooth devices is approximate 100 feet.
If
the
operator
leaves
the
range of operation and then comes back into range,
it
may take up
to
1 minute
for
device
to
automatically reconnect
to
the
light
kit.
In
a case where
the
smartphone does
not
reconnect,
simply repeat step 3 S
Ll
to
manually connect
the
kit
.
BATTERY
DRAW
CAUTION
The
device has a
low
but constant standby current draw.
If
the
bike
will
be
sitting
for
extended
periods
of
time, we suggest
the
installation
of
a main power switch.

Summary of content (3 pages)