Owner`s manual

21
Temp (Temperature) Display Screen
Displays temperature readouts, error messages, and power up readout:
LED Messages
1. HLnD, GrLL, 1.12 These three screens will display when the appliance is plugged into a
surge protector and then into an electrical outlet. This describes the make and model of
the board. (The 1.12 in this example identifies the software revision – your grill may
indicate a different version of software.)
2. 350. This is the default temperature at start up. The temperature setting range is from
180F to 650F while the actual temperature readout ranges from room temperature to
700F.
3. ER-1. This error code is to indicate the appliance has overheated.
4. ER-2. This error code indicates a failure to ignite. After pressing the ON touch pad, the
appliance must reach an operating temperature of 150F within 20 minutes. If it fails to
reach this temperature, the appliance will shut off and the error message will appear on
the display screen.
5. ER-3. This error code indicates a power failure causing the grill to cool.
Note: To reset an error, press on or off after correcting the problem
Temperature Display Screen
By pressing the display touch pad, the LED display screen will show either the actual
temperature within the appliance or the set-point. The LED besides actual or set-point is used to
indicate which temperature is presently displayed. Note: it is normal for the temp readout to vary
from time to time. This is caused by pellets being placed in the burn pot and the pellets burning
down until the controller calls for more pellets to be placed in to the burn pot. This works similar
to an oven when it turns off and on to maintain temperatures. As you preheat your grill, you will
see larger deviations in temperature. After the grill is preheated and the cooking temperature is
set, the temperature will stabilize within a normal range. An instant readout food temperature
probe is highly recommended to get accurate readings of your food.
Function Mode(Cook / Smoke) Touch Pad
By pressing the mode touch pad, the style of cooking and related pellet feed-rates will change.
The LED beside Cook or Smoke is used to indicate which mode is being used. A blinking LED
indicates the start up (igniter is on) or shut down (fans are running to cool the grill) status of the
grill.