Operation Manual

- 4 -
Touchscreen
Your SlidePad comes equipped with an easy-to-use touch-screen which allows access to the SlidePad’s
functions. Use your finger tip to touch the area of the screen where a control icon is displayed. If you touch
and hold the screen, it will register as a continuous button press.
To avoid damaging the screen, do not touch it with excessive force or with any object other than your finger.
For best response, make sure your hands are clean before using the touchscreen controls.
Protective film
A thin film has been applied to the touchscreen to protect it during shipping. The protective film should be
removed before use.
Battery charge
Use only the SlidePad delivered AC adapter, don’t use other plug to charge the SlidePad. It could damage
it.
To fully charge the SlidePad, plug the AC adapter inside and wait untill the battery indicator is full, when it
stops blinking by notifying charge level.
The orientation sensor
The SlidePad contains a sensor that will automatically change the orientation of most screens as you rotate
the SlidePad. The sensor works best when the SlidePad is rotated perpendicular to the ground. The
orientation sensor can be turned on and off in the Display settings menu.
Charging the SlidePad
The SlidePad comes with a built-in rechargeable lithium-polymer battery. Before using the SlidePad, the
battery should be fully charged. The Status Indicator will light green when the battery is fully charged.
To charge the battery:
1. Plug one end of the included power adapter into the AC 100-240V outlet.
2. Plug the other end of the included power adapter into the Power jack on the SlidePad.
3. Disconnect the power adapter when the SlidePad is fully charged.