Installation Instructions

5/8 x 48 x 96"
(1,6 x 121,9 x 243,8 cm)
PARTS REQUIRED:
Ensure your Á oor frame is square by installing one panel and squaring frame.
FLOOR PANELS
x1
2" (5,1 cm)
Fig. C
(2) Nails
Flush
Fig. A
Flush
at top
corner
edge.
Fig. B
(2) Nails
x53
Attach the 48 x 96" panel with the rough side up (painted-grid lines
side) with the 48" edge and corner  ush to the  oor frame (Fig A).
Secure panel with two 2" nails in the corners.
Move to the opposite end. Using the long edge of the panel as a lever move the
panel side-to-side until the top corner is  ush to the  oor frame (Fig. B).
Secure panel with two 2" nails in the corners.
2
BEGIN
1
3
4
Continue attaching the panel using 2" nails 6" apart on edges and 12" apart inside panel.
Use a chalk line or use pre-painted grid lines to nail into joists under panel.
Check the  oor frame is square by measuring diagonally across the frame corners. If the measurements
are the same, your  oor frame is square. The measurement will be approximately 133-5/16" (Fig. C).
96"
(243,8 cm)
133-5/16"
(338,6 cm)
133-5/16"
(338,6 cm)
92-1/2"
(235 cm)
48"
(121,9 cm)
Flush
12" (30,5 cm) inside panel.
Grid lines UP
3/4"
(1,9 cm)
Approximately
6" (15,2 cm)
edges of panel.
Flush
DOOR
10