Installation Instructions

25
2" (5,1 cm)
PARTS REQUIRED
x2
x17
BACK WALL INSTALLATION
3" (7,6 cm)
3" (7,6 cm)
x8
3" Nails into bottom plate.
(2) 3" (7,6 cm)
Screws
x17
1-1/2" (3,8 cm)
2
BEGIN
Stand back wall on  oor.
CENTER
Fig. C
Fig. B
Center back wall on  oor side to side.
Nail the lower back wall corner to the
side wall stud with one 2" nail (Fig. A).
1
2" (5,1 cm)
Nail
Fig. A
6"
(15,2 cm)
6"
(15,2 cm)
Ensure the measurement
between the panel edges is the
same along the entire length.
Then secure with one 2" nail in
the upper corner (Fig. B).
Nail along the panel edge into
the stud using 2" nails spaced 6"
apart.
Nail along bottom of panel using
2" nails 6" apart. Angle nail to hit
 oor frame (Fig. C).
3
Secure the back wall upright
to  oor using two 3" screws as
shown (Fig. D).
Nail the top plates at corners
using two 3" nails (Fig. E).
Remove temporary brace.
You have  nished standing your
back wall.
Fig. E
Fig. D
3" (7,6 cm)
Nails
2x3"
FINISH
4
Same
Measurement
2" (5,1 cm)
Nail
It is important to secure the
back wall in the following order:
D
O
O
R