Elevated Deer Blind SKU: 192-3452 Approximate Size: 6’ W x 6’ D x 13’ H www.menards.
Dimensions: Materials: PRODUCT 13’ 6’ AC2 Decking 2x4- 6’ AC2 Treated 2x6- 12’ AC2 Treated 2x4- 18’ AC2 Treated 12’-6” J-Trim 2-1/2” Exterior Deck screw 2-1/2” Exterior Deck screw 1” Wood Grip screw 10’ Corner and Gable trim Pro-Rib Outside Closure 10’ Universal Ridge Cap Camo-Panel 3’x30” Earth Anchor 1/2x3- 1/2 Lag screw SKU# DESCRIPTION QUANTITY 111-0614 111-0805 111-1040 111-0863 156-6404 230-5512 230-5552 230-1613 156-3980 155-8580 156-3981 155-8130 171-2762 232-2308 Pine Pine Pine Pine 1 lb.
Step 1: Frames 1) Gather four 2”x4”x6’, one 2”x6”x12’ and four 2”x4”x18’ in preparation to build a frame. Cut the 2”x6”x12’ board to 6’ and cut the 18’ boards to 12’. 2) Build the frame as pictured below. Be sure to extend the 2”x4”x6’ and 2”x6”x12’ boards 1-1/2” past the 12’ frame uprights. 3) Cut eight 2”x4” and two 2”x6” boards to 69” long 4) Stand upright frames and attach the frames with the 69” boards by lining up the boards with the end 1-1/2” overhang.
Step 3: Floor & Ladder Once the structure is standing, frame the floor as shown using the rest of the 2x6 boards. Do not space 2x6’s greater than 16” o.c. Lastly, add a ladder made out of 2x4’s. Frame section Double 2x412’ upright Opening may vary due to personal preference 21” 24” Frame section 3 Step 4: Floor Once floor is framed, use deck boards to make the floor. Some trimming will be necessary.
Step 5: Roof Frame To frame the roof, cut the top of the rafter to a 4/12 pitch and cut the bottom to match the laterals. Connect the rafters with a 2x4 on each side flush with the peak of the rafters to make the ridge. Step 6: Roof and Walls Refer to the Helpful Hints for Constructing Post Frame Buildings literature for attaching the steel siding and roofing.
Step 7: Rafters and Ridgecap Corner & Gable Residential Ridge Cap J-Trim Refer to the Helpful Hints for Constructing Post Frame Buildings literature for attaching the steel trims. Install Earth Anchors at all four corners at the base.