Operating instructions

MENDOTA DESIGNER FRONTS INSTALLATION INFORMATION

The following Designer Fronts are available for the DXV-42 Fireplace:

1. Andover Arched Door Kit or Prairie Rectangular Door kit with Firescreen with optional Overlays as listed below:

a. Black Overlay

b. Pewter Overlay

c. Antique Copper Overlay

d. 24K Gold

2. Deerfield Cast Scrolls Front

3. Wellington Firescreen Front

4. Black or 24K Gold Victoria Filigree

5. Black or 24K Gold Tuscany Filigree

6. Millenia Flat Grills in four optional color schemes as listed below:

a. Black Millenia Flat Grills

b. Full Brass Millenia Flat Grills

c. Classic Black and Brass Millenia Flat Grills

d. Classic Black and Bright Silver Millenia Flat Grills

Information specific to the installation of the Andover and Prairie Fronts

The Andover Door and Prairie Door Fronts are designed to be “Full-Face” trim kits. These two Fronts cover an area equivalent

to that shown in the diagram below. Any material that protrudes into this area on the sides, top or bottom edges can only be

flush with the front surface of the fireplace faceplate.

If planning to install either the Andover Door or the Prairie Door Front, DO NOT COVER THE FACEPLATE OF THE

FIREPLACE WITH ANY MATERIALS. Furthermore, any drywall or wall covering material that is adjacent to the sides, top

or bottom of the Fireplace’s faceplate may not protrude out past the front surface of the Fireplace Faceplate’s front surface.

The Andover and Prairie Doors Mounting Faceplate (required for installation of the Andover and prairie

Doors) may be covered over with noncombustible facing materials. See Figure 10, below.

To install Tile, Marble, Slate, Stone, Rocks or

other noncombustible facings to enhance the

arch shape of the Andover Doors or the

Rectangular shape of the Prairie Doors, do so

only after the Andover or Prairie Door Kits

have been installed on the DXV-42 Fireplace.

WARNING: COMBUSTIBLE

MATERIALS MUST NOT COVER

THE FRONT SURFACE OF THE

FIREPLACE’S FACEPLATE.

Figure 10