Operating instructions

MENDOTA WARRANTY QUALIFICATION & SERVICE REFERENCE FORM

As a part of Mendota's on-going program of customer satisfaction, this Form verifies proper installation and operation. It

is important as a reference for future service. It insures long life and trouble-free operation of Mendota fireplaces & stoves

and qualifies the owner for Mendota's lifetime limited warranty. Owner should sign Form when completed and mail a copy

along with Warranty Registration to Mendota. OPTIONALLY, PLEASE REGISTER AT OUR WEBSITE AT:

WWW.JOHNSONGAS.COM/MENDOTA-REGISTRATION.ASP

HOME OWNER: ____________________________ DEALER: _____________________________

ADDRESS: ________________________________ ADDRESS: ___________________________

CITY/STATE/ZIP: ___________________________ CITY/STATE/ZIP: ______________________

SIGNATURE: _______________________________ PHONE: ______________________________

MODEL #: DXV-45DT3LX __________________ SERIAL #: _____________________________

DATE INSTALLED: _____ ___________________

Mendota direct vent fireplaces are sophisticated, hi-tech gas appliances. All installation and operating instructions must

be carefully followed. The DXV fireplace must

be installed and serviced by a qualified Mendota approved service person.

REF: MENDOTA DXV45-DT3-LX INSTALLATION MANUAL

 APPROVED VENT PIPES AND VENT CAP INSTALLED - Per Manual.

Vent pipes must be fully twist-locked and leak proof.

Check minimum and maximum vertical / horizontal and vent runs.

 CHECK FOR PROPER CLEARANCES TO COMBUSTIBLES & VENT LOCATIONS - Per Manual

 INSTALL PROPER SIZE GAS LINES - CHECK FOR GAS LEAKS - Per Manual

 CHECK FOR CORRECT GAS PRESSURE AT MANIFOLD - Per Manual

a. 3.5 Inches Water Column Maximum - Nat. Gas (1/8” WC variation is allowed)

b. 10.0 Inches Water Column Maximum - L.P. Gas (1/8” WC variation is allowed)

 CYCLE BURNERS ON/OFF FOR PROMPT IGNITION - Per "LIGHTING INSTRUCTIONS"

Burner must light IMMEDIATELY - Flame must travel promptly around "curve" & light burner.

 INSTALL LOGS AND ADJUST FLAME - Per Manual

Proper pilot flame impingement on flame sensor & burner - Air shutter opening: 1/16" - 1/8" Nat. Gas - 1/4" LP

Check that flame is "stable" and is not "lifting" off burner

 BRIEF OWNER ON OPERATION AND MAINTENANCE OF UNIT

Light Pilot Operate Burner Explain blower "delay" operation

WARRANTY REGISTRATION

Your Name _______________________________________________________________

Address __________________________________________________________________

City ____________________________________ State _____ Zip ____________________

Dealer (Place of Purchase) ___________________________________________________

City ____________________________________ State _____ Zip ____________________

Date of Purchase ___________________ Serial Number ___________________________

Purchaser's Signature _______________________________________________________

MENDOTA DXV-45DT3 DIRECT VENT FIREPLACE

CUT OUT PAGE AND MAIL TO: JOHNSON GAS APPLIANCE CO., 520 E AVE. N.W., CEDAR RAPIDS, IOWA 52405

PLEASE REGISTER AT OUR WEBSITE AT: WWW.JOHNSONGAS.COM/MENDOTA-REGISTRATION.ASP