Operating instructions

MENDOTA DESIGNER FRONTS INSTALLATION INFORMATION

The following Designer Fronts are available for the DXV-45 Fireplace:

1. Andover Arched Door Kit with Firescreen with optional Overlays as listed below:

a. Black Andover Overlay

b. Pewter Andover Overlay

c. Antique Copper Andover Overlay

d. Gold Andover Overlay

2. Prairie Rectangular Door Kit with Firescreen with optional Overlays as listed below:

a. Black Prairie Overlay

b. Pewter Prairie Overlay

c. Antique Copper Prairie Overlay

d. Gold Prairie Overlay

3. Black or Gold Victoria Filigree

4. Black or Gold Tuscany Filigree

5. Millenia Flat Grills in four optional color schemes as listed below:

a. Black Millenia Flat Grills

b. Full Brass Millenia Flat Grills

c. Classic Black and Brass Millenia Flat Grills

d. Classic Black and Bright Silver Millenia Flat Grills

Information specific to the installation of the Andover and Prairie Fronts

The Andover Door and Prairie Door Fronts are designed to be “Full-Face” trim kits. These two Fronts cover an area equivalent to that

shown in the diagram below. Any material that protrudes into this area on the sides, top or bottom edges can only be flush with the

front surface of the fireplace faceplate.

If planning to install either the Andover

Door or the Prairie Door Front, DO NOT

COVER THE FACEPLATE OF THE

FIREPLACE WITH ANY MATERIALS.

Furthermore, any drywall or wall covering

material that is adjacent to the sides, top or

bottom of the Fireplace’s faceplate may not

protrude out past the front surface of the

Fireplace Faceplate’s front surface.

The Andover and Prairie Doors

Mounting Faceplate (required for

installation of the Andover and

prairie Doors) may be covered over

with noncombustible facing materials.

To install Tile, Marble, Slate, Stone, Rocks

or other noncombustible to enhance the arch

shape of the Andover Doors or the

Rectangular shape of the Prairie Doors, do

so only after the Andover or Prairie Door

Kits have been installed on the DXV-45

Fireplace.