Operating instructions

HEARTH PAD SURFACE MUST BE

FLUSH WITH FIREPLACE BOTTOM

HEARTH PAD

SURFACE

Hearth Protection Pad Installation Information when

planning to Install the Andover or Prairie Fronts

Any hearth protection pad installed in front of the DXV-45 Fireplace

must be designed, built and installed so that the hearth protection pad’s

top surface is flush with the bottom-most surface of the DXV45

Fireplace. See the diagram to the right.

Information specific to the installation of Millenia Flat Grills, Victoria Filigrees and Tuscany Filigrees

The Millenia Flat Grills, Victoria Filigree and Tuscany Filigree

are designed to be “inside-fit” trim kits. All of these trim kits fit

within the inner perimeter of the Fireplace’s Faceplate and

remain flush within the Faceplate’s front surface, see Figure

below. This fitting method allows flexibility in covering the

black visible surface of the Faceplate with non-combustible

materials such as Tile, Marble, Slate, Stone and Brick; as long as

enough room is allowed for the removal of these Mendota

Designer Fronts and the glass door for servicing,

WARNING: COMBUSTIBLE MATERIALS MUST

NOT COVER THE FRONT SURFACE OF THE

FIREPLACE’S FACEPLATE.