Installation manual

Speech Dialler Installation Manual
INS232-2 5
2. Installation
General
The unit requires a 12V @100mA DC power source, which is normally supplied by the
auxiliary power output of an intruder alarm control panel. If the unit is not connected to
an alarm control panel then a suitable power supply will be required.
A 1.5 metre telephone lead is supplied with the unit, which plugs directly into any
standard telephone socket. It is therefore recommended that the unit be sited as near
to a telephone socket as possible. If this it not possible an approved BT extension
lead may be required or the unit can be hard wired to the telephone socket using the
appropriate cable.
Mounting
1. Open the unit by carefully inserting a small flat-blade screwdriver into each slot
at the base of the unit. Gently push the screwdriver to ease the retaining clips
upward, DO NOT LEVER OR TWIST. Excessive force is NOT required.
2. Remove the front flap and front cover and unplug the loudspeaker from the
main circuit board.
3. Mount the unit using at least three appropriate countersunk screws (no larger
than No. 6). A keyhole slot has been provided to assist mounting and aid
leveling.
4. Pass the necessary cables into the base through the cable entries and then
secure the base of the unit to the wall.
The telephone cable must be routed into the base using either the top right
or bottom right knockout cable entry. A screw mount cable tie has been
provided to allow the telephone cable to be secured to the base of the unit.
The cable tie should be fitted to either the top or bottom right fixing holes.
#"