400 THANK YOU FOR VOTING TEXECOM INSTALLATION MANUAL External Sounder & Strobe Unit
Contents Section 1. Page Installation 3 1.1 Mounting the Unit 3 1.2 Patented Engineer Hold-Off Mode 3 1.3 Installing the Unit 3 1.3.1 Optional “Battery First” Connection Method 4 1.4 Installing Multiple Units 5 1.4.1 SCB Mode 5 1.5 Commissioning 6 2. Servicing 6 3. Safety 7 4. Technical Specification 8 5. Warranty 10 6.
1. Installation 1.1 Mounting the Unit Select a suitable position to mount the unit, which satisfies the following criteria: • • • • • Highly prominent for maximum deterrence Additional shelter (e.g. under the eaves) is an advantage High enough to be out of normal reach to deter tampering Safe ladder access Good cable access In addition to the corner screw fixing points, the unit also has a central keyhole to simplify mounting and aid levelling.
The following table illustrates how to connect the unit to the Texecom range and other control panels: Texecom Control Panel C&K Active 5, Securit Menvier TS510, 700, 800 Scantronic 9448 to 9800 A A BELL + BELL 12V +12V B B SBELL TRIG BELL C C 24 TAMPER BELL TMP TR D D AUX 0V 0V S S ST STB STR When connecting the unit to the control panel, it is recommended that wiring should be connected to the unit first and the control panel second. The unit should then be initially powered from the control panel.
1.4 Installing Multiple Units If more than one unit is connected to an installation, the current demand may exceed the rated current output of the control panel. This can be avoided by selecting the SCB mode on all but one of the connected units. 1.4.1 SCB Mode In this mode the unit draws the majority of its sounding current from the built-in battery rather than from the control panel.
1.5 Commissioning Most control panels have a method of testing the siren and strobe, which should be utilised for final testing. Failing this, simply arm the system and cause an alarm to confirm correct operation. Temporarily disconnect the positive supply to the unit at the control panel to confirm that the sounder self-activates. The strobe does not self-activate. Some control panels have an option to select the sounder cut-off time.
When the outer cover is replaced, and the tamper circuit is closed, the LEDs will alternate rapidly, confirming that the tamper circuit is secure and signalling that S/A on tamper will be re-enabled within 2 minutes, after which the LEDs will alternate slowly to signal normal operation. If the tamper circuit is re-opened within the 2 minute period, then Hold-Off mode will be restored. Slow flashing LEDs Left LED flashing only Right LED flashing only Fast flashing LEDs 3.
Failure to observe the following precautions regarding the battery could lead to the danger of heating, ignition or explosion: • • • • 4. Do not throw into a fire Do not heat Do not over-charge Do not reverse charge • • • Do not short-circuit Do not disassemble Replace only with the same or equivalent type Always observe local regulations when disposing of a battery. Plastic bags can suffocate - always dispose of packaging carefully.
Physical Material Azura 360, Tempest: Odyssey 1E, 2E, 3E & 4E: Odyssey 1, 2, 3 & 4: Orientation Azura 360, Tempest: Odyssey 1, 1E, 3 & 3E: Odyssey 2 & 2E: Odyssey 4 & 4E: Mounting: Tamper Detection Azura 360, Tempest: Odyssey 1E & 2E: Odyssey 1, 2, 3 & 4: Odyssey 3E & 4E: Dimensions Azura 360: Tempest: Odyssey 1 & 1E: Odyssey 2 & 2E: Odyssey 3 & 3E: Odyssey 4 & 4E: Packed Weight Azura 360, Tempest: Odyssey 1, 1E, 3, 3E, 4 & 4E: Odyssey 2 & 2E: Safety: EMC: Security Specific: 3mm polycarbonate 3mm poly
5. Warranty All Texecom products are designed for reliable, trouble-free operation. Quality is carefully monitored by extensive computerised testing. As a result the Azura 360, Tempest, Odyssey 1E, Odyssey 2E, Odyssey 3E and Odyssey 4E are covered by a two year warranty against defects in material or workmanship (details on request). The Odyssey 1, Odyssey 2, Odyssey 3 and Odyssey 4 are covered by a five year warranty.
6. Registered Installer Application Form Partially Completed Forms CANNOT be accepted. Please use Black Ink and Block Capitals. Name: Position: Company: Fax: Tel: E-Mail: Mobile: Website: Address: Country: Postcode: Which Distributors do you buy from? 1 (Indicate at least one).
There’s only ONE way to get FREE TECHNICAL SUPPORT... REGISTER! And receive the following exclusive benefits: • Access to the Secure Area of the Texecom Website • Freephone Technical Helpline* • Free Product Voucher* • Free Product Training* • Latest Product Information Register online at www.texe.com or simply complete the form on the reverse of this page and return it to Texecom to become a Registered Texecom Installer. *Available for UK registered Installers only. Texecom Limited.