Step 1 Assemble fall-prevention bar (E) Please place fall-prevention bar in the interlocking slots on the side panels and secure them with the rear interlocking block. Note: The fixing block needs to pass through the small rivets on the rear interlocking rod and correspond to the screw holes on the left and right sides of the interlace groove. ote: this step is installed.
Step 3 Connect the body Place the back panel and connect it to the side panel with self-tapping. Step 4 Assemble the top board (H) The top board should be placed at an angle, first buckle the back, then buckle the front, the side panel bulge and the back panel bulge are sequentially snapped into the top bracket.
Step 5 Assemble baseboard (R) Step 6 emblem lock bar (D) Install the base board. The base board is tilted into the cabinet, and the base The front locking bar has an arrow pointing upwards, and the hinge pin &t both board drum is buckled in the square hole of the left and right side lower ends of the inner transmission crossbar of the top plate is inserted inch the brackets. uppermost hole of the locking bar.
Step 7 Install outer drawer runners (I2 and J2) Attach the left outer drawer runner (I2) to the side panel (A). Attach the right outer drawer runner (J2) to side panel (B). Step 8 Install drawers K and M were reloaded together, so first M must be removed from K. Then open the drawer body (L), and attack L to K. Lastly, attach the front guard panel (4} and back guard panel (V). Please note: when installing L and K, be careful not to bend the two sides of the drawer body (L) many times in order to breaking.
Step 9 Separate drawer runners Pull out the runner core . Press the black part to take out the inside of the left drawer roomer (1), leaving two parts, Il and I2. Pull out the runner core. Press the black part to take out the inside of the right drawer runner (J), leaving two parts, J1 and J2) Step 10 Install inner drawer runners (I1, J1) Attach the left miner drawer roomers (I) to the left side of the assembled raver, and attach the right miner drawer runners (J1) to the right side of the assembled drawer.
Step 11 Finish assembly Insert the assembled drawer into the cabinet by re-inserting the miner runners to the outer runners. Then, attach the horizontal hook rail (0) and the two vertical hook rails (P). Once assembled open and close the file cabinet when unlocked. If the drawer is not closed completely, it may render the drawer unable to be locked.