Step 1 Assemble fall-prevention bar (H) Step 2 Assemble Body Please place fall-prevention bar in the interlocking slots on the The side panels should be placed horizontally, and the front and rear underside side panels and secure them with the rear interlocking block. frame are inserted one after the other and connected by self-tapping. Then press Note: The fixing block needs to pass through the small rivets an the black plastic inner plug into the squire tube.
Step 3 Connect the body Step 4 Assemble the top board (G) Piece the back panel and connect it to the side panel with self-tapping. The top board should be placed at an angle, first buckle the back, then buckle the front, the side panel bulge and the back peel bulge sre sequentially snapped into the top bracket.
Step 5 Assemble baseboard (R) Step 6 Assemble lock bar (D) Install the base board The base board is tilted into the cabinet, and the base The front locking ber has en arrow pointing upwards, end the hinge pin st both ';W: drub is buckled in the square hole of the left and right side lower ends of the inner transmission crosser of the top plate is inserted into the rackets. uppermost hole of the locking bar.
Step 7 Install outer drawer runners (I2 and J2) Attach the left outer drawer runner (I2) to the side panel (A). Attach the right outer raver roomer (J2) to side panel (B). Step 8 Install drawers K and M were reloaded together, so first M must be removed from K. Then open the drawer body (L), and attack L to K. Lastly, attach the front guard panel () and back guard panel (N). Please note: when installing L and K, be careful not to bend the two sides of the drawer body (L} many times in order to breaking.
Step 9 Separate drawer runners Step 10 Install inner drawer runners (Il, J1) Pull out the runner core . Press the black part to tee out the inside of the left Attach the left mire raver roomers (I1) to the left side of the assembled drawer Muter (1), leaving two parts, 11 and I2. oer " Pull out the rumor corp.
Step 11 Finish assembly Step 12 Finished Insert. the assembled drawer into the cabinet by re-inserting the inner roomers to the outer runners. Them, attach the horizontal hook rail (0) and the two vertices hook rails (F). Once assembled open and close the file cabinet when unlocked. If the drawer is mot closed completely, it may render the raver unable to be Locked.