Owners Manual

Entering an intermediate stop
Introduction
When route guidance is active, you can enter
an intermediate stop. Intermediate stops can
be predefined destinations from the following
categories that COMAND offers for selection:
R
Mercedes-Benz Service Center
R
Hospital
R
Gas Station
R
Parking Lot
R
Restaurant
However, you can also enter destinations
other than the predefined ones. To do this
select the menu item Other.
You can use the intermediate stop function to
influence route guidance to the main
destination. When you have reached your
intermediate stop, COMAND automatically
recalculates the route to the main
destination.
Entering predefined destinations
X
To activate navigation mode: press the
S function button once or twice.
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Select Stopover and press W to confirm.
Option 1: no intermediate stop has been
entered yet.
X
Select a category; see option 2.
Option 2: an intermediate stop has
already been entered.
X
Select Change Stopover and press W to
confirm.
X
To select a category: select a category by
turning cVd the COMAND controller and
pressing W to confirm.
COMAND first searches in the selected
category for destinations along the route.
If there are no destinations available there,
COMAND searches for destinations within
a radius of up to 100 km of the vehicle
position.
If COMAND finds destinations, a list
appears on the right-hand side of the
display. The currently selected point of
interest is highlighted on the left-hand side
of the map.
The intermediate stops are listed according
to increasing distance from the current
vehicle position. They are displayed in the
form of a name and their position in relation
to the route and your direction of travel.
If COMAND does not find any destinations,
you will see a message to this effect.
X
Confirm OK by pressing W.
X
Select a different category.
X
Select the intermediate stop by turning
cVd the COMAND controller and pressing
W to confirm.
X
To start route calculation: select Start
and press W to confirm.
Entering another destination as an
intermediate stop
X
To activate navigation mode: press the
S function button once or twice.
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Select Stopover and press W to confirm.
X
Select Other and press W to confirm.
Navigation
165
COMAND
Z