Owners Manual

save the home address without starting
route guidance.
X
To enter the home address for the first
time: select Assign Address Book
Entry and press W to confirm.
X
Select Home or Work and press W to
confirm.
X
To change the home address: select
Change and press W to confirm.
X
Select Assign Address Book Entry and
press W to confirm.
i
If you select New Entry, you are also
offered the option of changing the home
address by entering an address. You can
then save the home address without
starting route guidance.
X
Select Home or Work and press W to
confirm.
In both cases, you will see the address book
either with the character bar or as a
selection list.
X
To select an address book entry:
proceed as described in the "Searching for
an address book entry" section
(Y page 209).
X
To confirm the selection: press W the
COMAND controller.
If no home address has been stored,
COMAND saves the entry. You will see a
message and then the address menu with
the selected address. Start is highlighted
automatically.
If a home address has already been stored,
you will see a prompt asking you whether
the My Address entry should be
overwritten.
X
Select Yes or No and press W to confirm.
If you select Yes, COMAND overwrites the
destination. You will see a message and
then the address menu with the selected
address. Start is highlighted
automatically.
If you select No, the list will reappear.
Selecting the home address for route
guidance
X
Proceed as described in the "Selecting a
destination from the destination memory"
section (Y page 163).
Storing a destination in the destination
memory
Note
This function also stores the destination in
the address book.
After destination entry
X
The destination has been entered and is
shown in the address entry menu
(Y page 160).
X
Select Save by sliding VÆ and turning
cVd the COMAND controller and press
W to confirm.
You can now select storage options.
During route guidance
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
X
Select Save Destination and press W to
confirm.
You can now select storage options.
From the list of previous destinations
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
X
Select From Last Destinations and
press W to confirm.
The list of last destinations appears.
Navigation
183
COMAND
Z