Owners Manual

activating/deactivating Blind Spot
Assist
You can use the Blind Spot Assist
function to activate or deactivate Blind Spot
Assist (Y page 363) or Active Blind Spot
Assist (Y page 367).
X
Press the = or ; button on the
steering wheel to select the DriveAssist
menu.
X
Press 9 or : to select Blind Spot
Assist.
X
Press the a button.
The current selection is displayed.
X
To activate/deactivate: press the a
button again.
activating/deactivating Lane Keeping
Assist
You can use the Lane Keeping Assist
function to activate/deactivate Lane Keeping
Assist (Y page 365) or Active Lane Keeping
Assist (Y page 369).
X
Press the = or ; button on the
steering wheel to select the DriveAssist
menu.
X
Press 9 or : to select Lane
Keeping Assist.
X
Press the a button.
The current selection is displayed.
X
To activate/deactivate: press the a
button again.
When Lane Keeping Assist or Active Lane
Keeping Assist is activated, the à symbol
appears in the multifunction display when the
ignition is on.
Service menu
In the Service menu, you have the following
options:
R
call up display messages (Y page 390)
R
check the tire pressure electronically
(Y page 499)
R
call up the service due date (Y page 465)
R
check the oil level (Y page 459)
Settings menu
Introduction
The Settings menu can be used for:
R
Switching the daytime running lamps on/
off
R
switching Adaptive Highbeam Assist on/
off
R
showing or hiding the additional
speedometer
R
selecting the units for speed and distance
R
switching the belt adjustment on/off
R
activating/deactivating the radar sensor
system
Switching the daytime running lamps
on/off
This function is not available in Canada.
If you have activated the Daytime running
lights function and the light switch is in the
$ or c position, the daytime running
lamps are automatically switched on when
the engine is running.
Depending on the ambient light, the following
will additionally light up:
R
parking lamps
R
tail lamps
R
license plate lamp
R
side marker lamps
If you turn the light switch to a different
position, the corresponding lights are
switched on. If you switch off the daytime
running lamps at night, make sure that the
light switch is set to L or c.
The factory setting is On.
Menus and submenus
387
On-board computer and displays
Z