Owners Manual

Setting the compass
North America zone map
South America zone map
X
Set your location using the zone maps.
X
Press and hold button =(Y page 323) for
approximately three seconds.
The zone currently selected appears in
compass display ;(Y page 323).
X
To select the zone: press
button =(Y
page 323) repeatedly
until the
desired zone is selected.
The zone has been selected when compass
display ;(Y page 323) shows the heading.
This takes a few seconds.
Calibrating the compass
X
Make sure that there is sufficient space for
you to drive in a circle without impeding
traffic.
In order to calibrate the compass correctly,
do the following:
R
calibrate the compass in the open and not
in the vicinity of steel structures or high-
voltage transmission lines.
R
switch off electrical consumers
such as the
climate control, windshield wipers or rear
window defroster.
R
close all doors and the trunk lid/tailgate.
X
Switch on the ignition.
X
Press and hold button =(Y page 323) for
approximately six seconds until the
C symbol appears in compass display ;
(Y page 323).
X
Drive in a full circle at approximately
3 mph (5 km/h) to
6 mph (10 km/h).
When the
calibration has successfully been
completed, the current direction is shown
in compass display ;(Y page 323).
Floormat on the driver's side
G
WARNING
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Before driving off, check that the floormat is
securely
in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Do not place several floormats on top of each
other as this may impair pedal movement.
324
Features
Stowage and features