Owner's manual
X
Select Voice Control by turning cVd the
COMAND controller and press W to
confirm.
X
Select Help window and press W to
confirm.
You have switched the help window on
O or off ยช.
Individualization
Introduction
Using individualization, you can fine tune the
Voice Control System to your own voice and
thus improve voice recognition. This means
that other users' voices will not be recognized
as easily and, therefore, this function can be
switched off.
Individualization comprises two parts and
takes approximately five minutes. It consists
of training the system to recognize a certain
number of digit sequences and voice
commands.
Starting new individualization
Individualization can only be started when the
vehicle is stationary. Before starting, switch
off all devices or functions which could
interfere, such as the radio or the navigation
system. After starting the session, the system
guides you through the training with spoken
instructions.
X
Select Vehicle in the main function bar by
turning cVd the COMAND controller and
press W to confirm.
X
Select System by turning cVd the
COMAND controller and press W to
confirm.
X
Select Voice Control and press W to
confirm.
X
Select Start new individualization
and press W to confirm.
You see and hear a prompt asking whether
you would like further information.
X
Select Yes or No and press W to confirm.
If you select No, the first part of
individualization begins. You will be asked
whether you would like to train digits or
voice commands.
If you select Yes, you will see and hear
information on the individualization
process. The first part of individualization
then begins automatically.
X
To close the display: press W the
COMAND controller.
You will be asked whether you would like
to train digits or voice commands.
At the end of the first part, a prompt will
appear asking whether you wish to begin the
second part.
X
Select Yes or No and press W to confirm.
If you select No, individualization will be
canceled. The data from the first part is
stored automatically.
If you select Yes, the second part will begin.
System settings
131
COMAND
Z