Operating instructions

X
Slide VZ the COMAND controller repeat-
edly until the destination memory list
appears as a selection list.
Option 2: destination memory list as
selection list
The My AddressMy Address entry is listed as the first
entry in the destination memory.
X
Select My AddressMy Address by turning cVd the
COMAND controller and press W to con-
firm.
i
If you have not yet entered any charac-
ters, My AddressMy Address is automatically high-
lighted in the selection list.
If no home address has been stored yet, you
can now assign an address book entry. If a
home address already exists, it is displayed
and you can alter it.
i
If you select New EntryNew Entry, you are also
offered the option of entering the home
address for the first time. You can then
save the home address without having to
start route guidance.
X
To enter the home address for the first
time: select Assign to Address BookAssign to Address Book
EntryEntry and press W to confirm.
X
Select HomeHome, WorkWork or NotNot ClassifiedClassified and
press W to confirm.
X
To change the home address: select
ChangeChange and press W to confirm.
X
Select Assign to Address Book EntryAssign to Address Book Entry
and press W to confirm.
i
If you select New EntryNew Entry, you are also
offered the option of changing the home
address by entering an address. You can
then save the home address without having
to start route guidance.
X
Select HomeHome, WorkWork or NotNot ClassifiedClassified and
press W to confirm.
In both cases, you will see the address book
either with the character bar or as a selec-
tion list.
X
Select an address book entry
(Y page 148).
X
To confirm the selection: press W the
COMAND controller.
If there is no existing home address,
COMAND saves the entry. You will see a
message and then the address menu with
the selected address. StartStart is highlighted
automatically.
If a home address has already been stored,
you will see a prompt asking you whether
the My AddressMy Address entry should be overwrit-
ten.
X
Select YesYes or NoNo and press W to confirm.
If you select YesYes, COMAND overwrites the
destination. You will see a message and
then the address menu with the selected
address. StartStart is highlighted automati-
cally.
If you select NoNo, the list will appear again.
104
Destination memory
Navigation