Operating instructions

X
To show the menu: press W the COMAND
controller.
X
Select NaviNavi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Select MapMap SettingsSettings and press W to con-
firm.
The map settings menu appears.
X
Select Next Intersecting StreetNext Intersecting Street and
press W to confirm.
Depending on the previous status, switch
the option on O or off ª.
Traffic information on the map
:
Delimits the section of the route affected
;
Indicates an incident on the route (traffic
flow)
If you subscribe to the SIRIUS XM Satellite
Radio Traffic Message Service, traffic infor-
mation can be displayed on the map. You can
select three categories for the display.
X
To switch the display on/off: press W
the COMAND controller to show the menu.
X
Select NaviNavi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Select TrafficTraffic InformationInformation OnOn MapMap and
press W to confirm.
X
Select IncidentsIncidents and/or Speed & FlowSpeed & Flow
and/or Free FlowFree Flow and press W to con-
firm.
Depending on the previous status, switch
the option on O or off ª.
Traffic
information
Display on the map
Incidents Road sections with traffic
incidents are illustrated
with a yellow line and
arrows.
Speed &
Flow
Road sections with traffic
jams are represented by yel-
low or red lines.
Yellow lines: traffic jams,
average speed 25 - 45 mph
(40 - 72 km/h)
Red lines: traffic jams, aver-
age speed 5 - 20 mph
(8 - 32 km/h)
Free Flow Free flowing road sections
are illustrated with a green
line and arrows.
Additional settings
Avoiding an area
General information
COMAND enables you to avoid areas you do
not wish to drive through.
If you activate or deactivate a route block
while route guidance is active, COMAND will
calculate a new route. If you activate or deac-
tivate a route block while route guidance is
inactive, COMAND will use the new setting for
the next route guidance.
114
Additional settings
Navigation