Operating instructions

The calculated route may include an area to
be avoided if:
R
your destination is located in such an area.
R
the route uses roads that lead through an
area to be avoided.
i
Highways within blocked areas are always
taken into consideration in the route cal-
culation.
Defining an area for the first time
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select NaviNavi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Select Avoid AreaAvoid Area and press W to con-
firm.
If you have not previously blocked an area,
a menu appears.
X
Select Using MapUsing Map, From MemoryFrom Memory or FromFrom
Personal POIsPersonal POIs and press W to confirm.
If you select Using MapUsing Map, the map with the
crosshair appears.
If you select From MemoryFrom Memory or From Per‐From Per‐
sonal POIssonal POIs, either the destination mem-
ory or the list of categories for POIs
appears.
R
Destination memory (Y page 70)
R
List of categories for personal POIs
(Y page 85)
X
Select the desired destination or personal
POI and press W to confirm.
X
When the destination address is displayed,
select ContinueContinue and press W to confirm.
The map appears.
The crosshair marks the center of the area
that is to be avoided.
X
To scroll the weather map: slide XVY,
ZVÆ or aVb the COMAND controller.
X
To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears. Turning clockwise zooms out from
the map; turning counter-clockwise zooms
in.
X
Turn cVd until the desired scale is set.
X
To apply a block: press W the COMAND
controller.
A red square appears on the map.
X
To adjust the size of the square: turn
cVd the COMAND controller.
The square is enlarged or reduced.
X
To confirm the settings: press W.
The list appears. The previously selected
area to be avoided has been added and
activated.
You can also determine additional areas to be
avoided (Y page 116).
Additional settings
115
Navigation
Z