Operating instructions

Selecting a destination from the des-
tination memory (e.g. My address)
Introduction
The destination memory always contains an
entry named "My Address". You may wish to
assign your home address to this entry, for
example (Y page 69), and select it for route
guidance. This entry is always located at the
top of the list in the destination memory.
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select DestinationDestination in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Select From MemoryFrom Memory and press W to con-
firm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Option 1: destination memory list with
character bar
:
Character entered by the user
;
Characters automatically added by the
system
=
List entry most closely resembling the
characters entered so far
?
Switches to the selection list
A
Deletes an entry
B
Characters not currently available
C
Character bar
D
Currently selected character
E
Cancels an entry
F
Characters currently available
X
Enter a destination, e.g. "My Address".
Character entry, using city input as an
example (Y page 36).
Option 2: destination memory list as
selection list
Destination memory list
X
Select My AddressMy Address by turning cVd the
COMAND controller.
X
Irrespective of the option, press W to con-
firm your selection.
The address entry menu appears again.
"My Address" has been entered.
X
To start route calculation: select StartStart
and press W to confirm.
Entering a destination from the list of
last destinations
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select DestinationDestination in the navigation sys-
tem menu bar by turning cVd the
70
Destination input
Navigation