Operating instructions

ManualsBrandsMercedes-Benz ManualsAutomotiveCOMAND

To select a destination: press W the

COMAND controller once or several times.

If COMAND is unable to assign a unique

address, you will see either the address

entry menu with the destination address or

a selection list.

Select a destination by turning cVd the

COMAND controller and press W to con-

firm.

If the destination is within the limits of the

digital map, COMAND attempts to assign

the destination to the map.

If the destination can be assigned, you will

see the address entry menu with the

address of the destination. If not, you will

see the Destination From MapDestination From Map entry.

To start route calculation: select StartStart

and press W to confirm.

Entering a destination using geo-coor-

dinates

To switch to navigation mode: press the

Ø button.

To show the menu: press W the COMAND

controller.

Select DestinationDestination in the navigation sys-

tem menu bar by turning cVd the

COMAND controller and pressing W to

confirm.

Select Using Geo-CoordinatesUsing Geo-Coordinates and

press W to confirm.

An entry menu appears.

You can now enter the latitude and longitude

coordinates with the COMAND controller or

the number keypad (Y page 36).

To change a value: turn cVd the

COMAND controller.

To move the mark within the line: slide

XVY the COMAND controller.

To move the mark between the lines:

slide ZVÆ the COMAND controller.

To confirm the value: press W the

COMAND controller.

If the selected position is outside the dig-

ital map, COMAND uses the nearest digi-

tized road for route calculation. You will see

the TheThe coordinatescoordinates areare outsideoutside thethe

mapmap areaarea message. If the selected position

is located over a body of water, you will see

the message: The destination is inThe destination is in

a body of water. Please selecta body of water. Please select

another destination.another destination.

Entering a destination using

Mercedes-Benz Apps