Operating instructions

on the map varies according to the icon.
You can select the icons that you want
COMAND to display.
If no points of interest are available, you will
see a message to this effect.
i
You also see this message if you have
selected the NoNo SymbolsSymbols menu item under
"Map display" (Y page 110).
X
To confirm the message: press W the
COMAND controller.
X
To select a POI: select NextNext or PreviousPrevious
and press W to confirm.
X
To show details for the selection: select
DetailsDetails and press W to confirm.
X
To change to the map: slide ZV the
COMAND controller.
You can move the map and select the map
section.
X
To start route calculation: select StartStart
and press W to confirm.
A prompt appears asking whether the point
of interest should be used as the destina-
tion.
X
Select YesYes or NoNo and press W to confirm.
i
Cont.Cont. is displayed instead of StartStart when
Calculate Alternative RoutesCalculate Alternative Routes is acti-
vated in the navigation menu
(Y page 93).
Personal POIs
General notes
i
The use of personal POIs for displaying
traffic surveillance equipment is not per-
mitted in every country. Please observe the
country-specific regulations and adapt
your speed accordingly when driving.
Settings
Calling up the "Personal POIs" menu
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select NaviNavi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X
Select Personal POIsPersonal POIs and press W to
confirm.
Displaying personal POIs on the map
The personal POIs are shown on the map with
an icon according to their category.
X
Call up the "Personal POIs" menu
(Y page 82).
X
Select Display Personal POIs On MapDisplay Personal POIs On Map
in the menu and press W to confirm.
You can select different categories.
82
Personal POIs
Navigation