Operating instructions

X
To select a destination: press the con-
troller.
The list contains the MenuMenu menu item. If
there are multiple destinations around the
crosshair, a selection list will also appear.
X
To show the menu: press the controller.
X
To select a destination from the selection
list: turn and press the controller.
If the digital map provides navigable
address data, you will see the destination
address in the address entry menu. If not,
the Destination from Map, Date_1,Destination from Map, Date_1,
Time_1Time_1entry is shown.
X
To start route calculation: select StartStart.
Entering way points
Introduction
You can also map the route to the destination
yourself by entering up to four way points. The
sequence of the way points can be changed
at any time.
COMAND provides a selection of predefined
destinations in eight categories for this pur-
pose, e.g. GAS STATIONGAS STATION or RESTAURANTRESTAURANT. You
can also use the destination entry options to
enter way points.
Creating way points
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: slide 6 the control-
ler.
X
To select DestinationDestination: turn and press the
controller.
X
Select Way PointsWay Points.
The destination is entered into the way
points menu. The way points are not yet
entered.
X
To select Add New:Add New: : press the controller.
X
To select a category or OtherOther: turn and
press the controller.
After selecting a category, the POIs which
are available along the route and in the
vicinity are displayed.
COMAND first searches for destinations
along the route. The search for destinations
is then initiated in the area around the vehi-
cle position.
X
After selecting OtherOther, select one of the
destination entry options from the list.
76
Destination input
Navigation