Operating instructions

Highways within blocked areas are always
taken into consideration in the route calcula-
tion.
Avoiding a new area
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: slide 6 the control-
ler.
X
To select OptionsOptions: turn and press the con-
troller.
X
Select Route SettingsRoute Settings.
X
Select Avoid/Use OptionsAvoid/Use Options.
X
Select Avoid AreaAvoid Area.
X
Select Avoid New AreaAvoid New Area.
A menu appears.
X
Select Using MapUsing Map or Address EntryAddress Entry.
If you select Using MapUsing Map, the map with
crosshair appears.
If you select Address EntryAddress Entry, the address
entry menu appears where you can enter
the address (Y page 67). The map appears
with the crosshair after the address is
entered.
i
Alternatively, you can carry out this oper-
ation using the touchpad (Y page 21).
X
To select an area: when the map with
crosshair appears, press the controller.
A red square appears on the map, symbol-
izing the area to be blocked.
X
To change the size of the area, turn the
controller.
The map scale is shown at the bottom of
the display. The needle is on the map scale
currently selected.
X
When the desired size is set, press the con-
troller.
The area is entered into the list.
Avoiding an area: functions
X
To switch to navigation mode: press the
ß button.
X
To show the menu: slide 6 the control-
ler.
X
To select OptionsOptions: turn and press the con-
troller.
X
Select Route SettingsRoute Settings.
X
Select Avoid/Use OptionsAvoid/Use Options.
X
Select Avoid AreaAvoid Area.
The "Avoid area" list appears.
Map functions
95
Navigation
Z