Operating instructions

X
To start route calculation: select Start
and press the 9 button to confirm.
Aprompt appears asking whetherthe point
of interest should be used as the
destination.
X
Select Yes or No and press the 9 button
to confirm.
If you select Yes, route calculation begins.
If you select No, you can select a new point
of interest.
Route guidance
General information
G
WARNING
COMAND calculates the route to the
destination without taking account of the
following, for example:
R
traffic lights
R
stop and give way signs
R
parking or stopping restrictions
R
lane narrowing
R
other road and traffic rules and regulations
COMAND may give incorrect driving
recommendations if the data on the digital
map does not correspond to the actual
conditions, e.g. the road layouthas changed.
For this reason, you must always observe the
respective road and traffic rules and
regulations during your journey. Road and
traffic rules and regulations always have
priority oversystem driving
recommendations.
Route guidance begins once aroute has been
calculated (Y page 51).
COMAND guides you to your destination by
means of navigation commands in the form
of audible navigation announcements and
route guidance displays.
The route guidance displays can only be seen
if the display is switched to navigation mode.
If you do not follow the navigation
announcements or if you leave the calculated
route, COMAND automatically calculates a
new route to the destination.
If the digital map contains the corresponding
information, the following applies:
R
when selecting a route, COMAND tries to
avoid roads that only have limited access,
e.g. roads closed to through traffic and non-
residents.
R
roads that have time restrictions (e.g.
closed on Sundays and public holidays) are
avoided for route guidance.
Switching between the full-screen
map and the change-of-direction
display
X
Press the ß button.
COMAND switches to the respective
display.
Change of direction
Introduction
Changes of direction have three phases:
R
Preparation phase
R
Announcement phase
R
Change-of-direction phase
Preparation phase
COMAND prepares you for the upcoming
change of direction.Based on the example
display below, the change of direction is
announced with the Prepare to turn
right message. The map can be seen in the
full-screendisplay.
Route guidance
65
Navigation
Z