Operator's Manual

232
Controls in detail
Power windows
Fully opening the windows
(Express-open)
왘 Press switch 1 to 4 past the resis-
tance point and release.
The corresponding window opens com-
pletely.
Fully closing the windows
(Express-close)
왘 Pull switch 1 to 4 past the resis-
tance point and release.
The corresponding window closes com-
pletely.
Stopping windows during
Express-operation
왘 Press or pull respective power window
switch again.
Synchronizing power windows
The power window must be resynchro-
nized each time
앫 after the battery has been
disconnected
앫 if the power windows cannot be fully
opened (Express-open) or closed
(Express-close)
Synchronizing
왘 Close all doors.
왘 Switch on the ignition (컄 page 34).
왘 Pull and hold the power window
switches 1 to 4 until the side win-
dows are completely closed.
With the side windows completely
closed, hold the switches for approxi-
mately three seconds.
The power windows are synchronized.
Warning! G
Driver’s door only:
If within five seconds switch is again pulled
past the resistance point and released, the
automatic reversal will not operate.
!
If the upward movement of the window
is blocked during the closing proce-
dure, the window will stop and open
slightly.
Remove the obstruction, pull the re-
spective power window switch again
past the resistance point and release.
If the window still does not close when
there is no obstruction, then pull and
hold the respective power window
switch. The side window will then close
without the obstruction sensor func-
tion.