Operation Manual

Redialing
The control system stores the most recently
dialed phone numbers. This eliminates the
need to search through your entire phone
book.
X
Press button U
or V repeatedly until
the message TEL appears in the
multifunction display.
X
Press button 6.
The first number in the redial memory
appears in the multifunction display.
X
Press button &
or * repeatedly until
the desired number or name appears in the
multifunction display.
X
Press button 6.
The control system dials the selected
phone number.
Driving systems
Introduction
This section describes the following driving
systems of your vehicle:
R
Cruise control
R
Distronic
R
Distance warning function (only available
with Distronic)
R
Hill-start assist system
R
Rear-axle level control
R
AIRMATIC
R
All-wheel drive (4MATIC)
R
Parktronic system
R
Rear view camera
The
driving safety systems ABS, BAS, EBP and
ESP
®
are described in the “Safety and
security” section (Y page 63).
Cruise control
The cruise control maintains the speed you
set for your vehicle automatically.
The
use of the cruise control is recommended
for driving at a constant speed for extended
periods of time.
The currently set speed or last set speed
(“Resume” function) appears in the status
indicator of the multifunction display:
R
USA only: e.g. Cruise 55 Miles
R
Canada only: e.g. ¯ 90 Km/h
G
Warning!
The cruise control is a convenience system
designed to assist the driver during vehicle
operation. The driver is and must always
remain responsible for the vehicle’s speed
and for safe brake operation.
Only
use the cruise control if the road, traffic,
and weather conditions make it advisable to
travel at a constant speed.
R
The use of the cruise control can be
dangerous on winding roads or in heavy
traffic because conditions do not allow safe
driving at a constant speed.
R
The use of the cruise control can be
dangerous on slippery roads. Rapid
changes in tire traction can result in wheel
spin and loss of control.
R
Deactivate the cruise control when driving
in fog.
The “Resume” function should only be
operated if the driver is fully aware of the
previously set speed and wishes to resume
this particular preset speed.
142
Driving systems
Controls in detail
251_AKB; 4; 52, en-US
d2ureepe, Version: 2.11.8.1
2009-03-23T09:22:52+01:00 - Seite 142