Operation Manual

!
Please keep in mind that weather
conditions can sometimes change rapidly.
Make sure to close the tilt/sliding panel
when leaving the vehicle. If water enters
the vehicle interior, vehicle electronics
could be damaged which is not covered by
the Mercedes-Benz Limited Warranty.
Roof panel switch
:
Raising
;
Opening
=
Closing
The tilt/sliding panel only operates with the
roller sunblinds retracted.
i
You can also open or close the tilt/sliding
panel using the SmartKey, see “Summer
opening feature” (Y page 108) or see
“Convenience closing feature”
(Y page 108).
X
Switch on the ignition.
Opening
X
Opening manually: Press and hold the
roof panel switch to the resistance point in
direction of arrow ;.
X
Release the roof panel switch when the
desired position is reached.
X
Express operation: To open the tilt/
sliding panel completely, press the roof
panel switch past the resistance point in
direction of arrow ; and release.
X
Stopping during express operation:
Move the roof panel switch in any direction.
i
Express opening is not available when the
tilt/sliding panel is raised. The tilt/sliding
panel must be closed first.
i
When the tilt/sliding panel is open,
resonance noises may result in addition to
the usual wind noises. They are caused by
minimal pressure changes in the passenger
compartment. To reduce or eliminate these
noises, change the position of the tilt/
sliding panel or open a window slightly.
Raising
X
Raising manually: Press and hold the roof
panel switch in direction of arrow :.
X
Release the roof panel switch when the
desired position is reached.
Closing
X
Closing manually: Pull and hold the roof
panel switch in direction of arrow =.
X
Release the roof panel switch when the
desired position is reached.
Closing when the tilt/sliding panel is
blocked
G
Warning!
Make sure that nobody can become trapped
and be seriously or even fatally injured when
closing the tilt/sliding panel without
automatic reversal function.
If the movement of the tilt/sliding panel is
blocked during the closing procedure (e.g. by
ice or pollution), the tilt/sliding panel will stop
and open slightly.
X
Immediately after the tilt/sliding panel has
stopped and opened because it was
blocked, pull and hold the roof panel switch
in direction of arrow = until the tilt/sliding
panel is fully closed.
Panorama roof with power tilt/sliding panel
185
Controls in detail
251_AKB; 4; 52, en-US
d2ureepe, Version: 2.11.8.1
2009-03-23T09:22:52+01:00 - Seite 185
Z