Operation Manual

X
On the wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with wheel
wrench :).
X
Assemble the jack (Y page 272).
The jack take-up brackets are located directly
behind the front wheel housings and in front
of the rear wheel housings.
G
Warning!
The jack is designed exclusively for jacking up
the vehicle at the jack take-up brackets. Make
sure the jack arm is fully seated in the jack
take-up bracket.
If you do not position the jack correctly in the
jack take-up bracket, the vehicle can fall off
the jack and seriously or fatally injure you or
others.
!
Do not position the jack on the body of
the vehicle, as this may cause damage to
the vehicle.
X
Attach reversible ratchet ? to jack = in
such a way that the word UP can be seen.
X
Place jack = on firm ground.
X
Position jack = under take-up
bracket ; so that it is always vertical as
seen from the side, even if the vehicle is
parked on an incline.
X
Turn ratchet ? up and down until jack =
is fully seated in take-up bracket ; and the
jack base evenly meets the ground.
X
Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the ground.
326
Flat tire
Practical hints
251_AKB; 4; 52, en-US
d2ureepe, Version: 2.11.8.1
2009-03-23T09:22:52+01:00 - Seite 326