Operation Manual

Each memory position button on the driver’s
side can store all of the following settings:
R
Seat position
R
Steering wheel position
R
Exterior rear view mirrors’ position
G
Warning!
Do not activate the memory function while
driving. Activating the memory function while
driving could cause the driver to lose control
of the vehicle.
Each memory position button on the front
passenger side can store the setting of the
seat position.
Storing positions into memory
X
Adjust the seats.
X
On the driver’s side, also adjust the
steering wheel and exterior rear view
mirrors to the desired positions.
X
Press memory button M once and within
3 seconds press memory position button
1, 2 or 3.
When the settings are stored to the
selected position, an acknowledgement
signal sounds.
Recalling positions from memory
X
Press and hold desired memory position
button 1, 2 or 3 until the seat has moved
to the stored position completely. On the
driver’s side, also wait for the steering
wheel and exterior rear view mirrors to
move to the stored position.
i
Releasing the memory position button
stops movement to the stored positions
immediately.
Lighting
Notes
i
If you drive in countries with left-hand
driving, you must have the headlamps
modified for symmetrical low beams.
Relevant information can be obtained at
any authorized Mercedes-Benz Center.
i
Vehicles equipped with active Bi-Xenon
headlamps:
The active Bi-Xenon headlamps increase
usable illumination over conventional
headlamps because they follow the
curvature of the road ahead. The beams of
the active Bi-Xenon headlamps shift to
either side according to the vehicle’s
steering angle and speed.
Exterior lamp switch
1 W
Standing lamps, left
2 X
Standing lamps, right
3 $
Off
Daytime running lamp mode
4 Ã
Automatic headlamp mode
Daytime running lamp mode
Lighting
97
Controls in detail
251_AKB; 4; 52, en-US
d2ureepe, Version: 2.11.8.1
2009-03-23T09:22:52+01:00 - Seite 97
Z