Operation Manual

X
On the side where the bulb is to be
replaced, unclip the remaining part of trim
D from the assembly using a sudden,
sharp movement, until the bulb holder is
accessible.
X
Remove bulb holder E using both sides of
lever F.
Bulb holder
X
Backup lamp G: remove the bulb from
bulb holder E.
X
Insert the new bulb into the bulb holder.
X
Rear fog lamp H: press the bulb gently
into bulb holder E, turn it counter-clock-
wise and remove it from the bulb holder.
X
Insert the new bulb into the bulb holder and
turn it clockwise.
X
Reinsert the bulb holder until you hear it
engage audibly.
X
Position paneling D and engage it in place
by tapping it with your hand.
X
Before continuing with the installation,
check that all the metal clips are inserted in
the parts placed to one side: 2 clips ; in
the upper part of handle = and 5 clips A
in paneling B.
X
If not, remove the missing metal clips from
the metal openings in the tailgate and
insert them in the appropriate places.
X
Take paneling B and connect plug con-
nector C to the surround lighting.
i
The surround lighting only illuminates
when the tailgate has been shut and reop-
ened.
X
Position paneling B and engage it in place
by tapping it with your hand, starting from
the outside.
X
Clip in the lower section of handle : again.
X
Insert and engage the upper section of han-
dle = into lower section :.
License plate lamp
X
Switch off the lights.
X
Open the tailgate.
110
Replacing bulbs
Lights and windshield wipers