Operation Manual

computer are different, the high-voltage bat-
tery is charged using the lower value.
If the vehicle requires more time than usual to
charge the high-voltage battery, check:
R
the settings of the maximum charge cur-
rent on the controls of the charging cable
R
the settings of the maximum charge cur-
rent in the menu of the on-board computer
Connecting the charging cable
:
To open the charge socket flap
;
Tire pressure table
=
Socket cap
?
Fastener
A
Vehicle socket
B
Warning sticker
X
Shift the DIRECT SELECT lever to position
P.
X
Switch the ignition off.
X
Press the charge socket flap in the direc-
tion of arrow :.
The charge socket flap swings up.
X
Slide fastener ? to the right.
Socket cap = is open.
X
Insert the power supply plug into the elec-
trical outlet to the stop.
X
Insert the charging cable connector into
vehicle socket A to the stop.
The high-voltage battery is being charged.
The vehicle must not be moved while the
charging cable is connected or during charg-
ing.
i
Depending on the temperature, the
engine cooling system and battery cooling
system may audibly switch on when the
charging cable is connected or during the
charging process.
Removing the charging cable
!
Before driving away, you must ensure
that, for your own safety and to avoid dam-
age, the charging cable has been removed
from the vehicle socket. Otherwise, you
cannot shift the transmission out of posi-
tion P.
When the charge level display reaches 100%,
the battery is fully charged (Y page 184).
When the battery is charged:
X
Press and hold button C on the charging
cable connector and remove the charging
cable from vehicle socket A.
X
Close socket cap =.
X
Close the charge socket flap.
148
High-voltage battery
Driving and parking