Operation Manual

X
Remove the charging cable from the elec-
trical outlet.
X
Stow the charging cable safely in the vehi-
cle (Y page 146).
Charging a high-voltage battery at a
charging station/wallbox
General notes
Only use charging cables that have been tes-
ted and approved by the manufacturer for
charging the high-voltage battery in an elec-
tric vehicle.
Pay attention to the "Important safety notes"
(Y page 140).
Charging communication at a charging
station
The charging station first has to be activated
before you can charge at a charging station.
You can activate the charging station by using
an RFID card or via telephone activation.
Observe the on-site operator instructions for
the charging station.
When the vehicle is connected to the charging
station, information and details on technical
parameters are exchanged. It can thus take
up to 30 seconds for the charging process to
begin.
Connecting the charging cable
:
To open the charge socket flap
;
Tire pressure table
=
Socket cap
?
Fastener
A
Vehicle socket
B
Warning sticker
X
Shift the DIRECT SELECT lever to position
P.
X
Switch the ignition off.
X
Press the charge socket flap in the direc-
tion of arrow :.
The charge socket flap swings up.
X
Slide fastener ? to the right.
Socket cap = is open.
X
Insert the charging cable connector into
vehicle socket A to the stop.
The high-voltage battery is being charged.
The vehicle must not be moved while the
charging cable is connected or during charg-
ing.
i
Depending on the temperature, the
engine cooling system and battery cooling
High-voltage battery
149
Driving and parking
Z