Operation Manual

Observe the complete closing procedure
when the convenience closing feature is oper-
ating. Make sure that no body parts are in
close proximity during the closing procedure.
Vehicles with KEYLESS-GO, the KEYLESS-
GO start function, Exclusive Package or
AMG Exclusive Package: when you lock the
vehicle, you can close the side windows at the
same time.
i
Notes on the automatic reversing feature
for the side windows (Y page 83).
Using the SmartKey
X
Vehicles with Exclusive Package or
AMG Exclusive Package but without
KEYLESS-GO and the KEYLESS-GO start
function: for the following operations,
point the tip of the SmartKey at the door
handle on the driver's door. The SmartKey
must be close to the driver's door handle.
i
Vehicles with KEYLESS-GO or the KEY-
LESS-GO start function: the SmartKey
must be in close proximity to the vehicle.
X
Press and hold the & button until the
side windows are fully closed.
X
To interrupt convenience closing:
release the & button.
Using KEYLESS-GO
The driver's door and the door at which the
handle is used, must both be closed. The
SmartKey must be outside the vehicle. The
gap between the SmartKey and the corre-
sponding door handle should not be greater
than 3 ft (1 m).
X
Touch recessed sensor surface : on the
door handle until the side windows are fully
closed.
i
Make sure you only touch recessed sen-
sor surface :.
X
Make sure that all the side windows are
closed.
X
To interrupt convenience closing:
release recessed sensor surface : on the
door handle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
X
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
ignition lock (Y page 131).
X
Pull the corresponding switch on the door
control panel until the side window is com-
pletely closed (Y page 84).
X
Hold the switch for an additional second.
If the side window opens again slightly:
X
Immediately pull the corresponding switch
on the door control panel until the side win-
dow is completely closed (Y page 84).
X
Hold the switch for an additional second.
X
If the respective side window remains
closed after the button is released, then it
has been set correctly. If this is not the
case, repeat the steps above again.
Side windows
85
Opening and closing
Z