Operation Manual

light switch to T, the daytime running lamps
and parking lamps switch on.
If the engine is running and you turn the light
switch to L, the manual settings take prec-
edence over the daytime running lamps.
USA only:
The daytime running lamps improve the visibility
of your vehicle during the day. To do this, the
daytime running lamps function must be
switched on using the on-board computer
(
Y page 206).
If the engine is running and you turn the light
switch to T or L, the manual settings
take precedence over the daytime running
lamps.
Low-beam headlamps
G
WARNING
When the light switch is set to Ã, the low-
beam headlamps may not be switched on
automatically if there is fog, snow or other
causes of poor visibility due to the weather
conditions such as spray. There is a risk of an
accident.
In such situations, turn the light switch to
L.
Even if the light sensor does not detect that it is
dark, the parking lamps and low-beam head-
lamps switch on when the ignition is switched on
and the light switch is set to the L position.
This is a particularly useful function in the event
of rain and fog.
X
To switch on the low-beam headlamps:
turn the SmartKey in the ignition lock to posi-
tion 2 or start the engine.
X
Turn the light switch to L.
The green L indicator lamp in the instru-
ment cluster lights up.
Parking lamps
!
If the battery charge is very low, the parking
lamps or standing lamps are automatically
switched off to enable the next engine start.
Always park your vehicle safely and suffi-
ciently lit according to legal standards. Avoid
using the parking lamps T over a period of
several hours. If possible, switch on the right-
hand X or left-hand W standing lamp.
X
To switch on: turn the light switch to T.
The green T indicator lamp in the instru-
ment cluster lights up.
Standing lamps
Switching on the standing lamps ensures the
corresponding side of the vehicle is illuminated.
X
To switch on the standing lamps: the
SmartKey should not be in the ignition lock or
it should be in position 0.
X
Turn the light switch to W (left-hand side of
the vehicle) or X (right-hand side of the
vehicle).
Combination switch
:
High-beam headlamps
;
Turn signal, right
=
High-beam flasher
?
Turn signal, left
X
To indicate briefly: press the combination
switch briefly to the pressure point in the
direction of arrow ; or ?.
The corresponding turn signal flashes three
times.
X
To indicate: press the combination switch
beyond the pressure point in the direction of
arrow ; or ?.
X
To switch on the high-beam headlamps
manually: turn the SmartKey to position 2 in
the ignition lock or start the engine.
X
Vehicles without Adaptive Highbeam Assist:
turn the light switch to L or Ã.
X
Vehicles with Adaptive Highbeam Assist: turn
the light switch to L.
108
Exterior lighting
Lights and windshield wipers