Operation Manual

R
Only use the "Windshield defrosting" function
briefly until the windshield is clear again.
R
Only use air-recirculation mode briefly, e.g. if
there are unpleasant outside odors or when in
a tunnel. The windows could otherwise fog up,
since no fresh air is drawn into the vehicle in
air-recirculation mode.
R
Use the ZONE function to adopt the temper-
ature settings on the driver's side for the
front-passenger side and the rear compart-
ment as well. The indicator lamp above the
á button goes out.
R
Vehicles with 3-zone automatic climate con-
trol: use the residual heat function if you want
to heat or ventilate the vehicle interior when
the ignition is switched off. The residual heat
function can only be activated or deactivated
with the ignition switched off.
R
If you change the settings of the climate con-
trol system, the climate status display
appears for approximately three seconds at
the bottom of the screen in the multimedia
system display. You will see the current set-
tings of the various climate control functions.
ECO start/stop function
During automatic engine switch-off, the climate
control system only operates at a reduced capa-
city. If you require the full climate control output,
you can switch off the ECO start/stop function
by pressing the ECO button (
Y page 131).
Operating the climate control sys-
tems
Activating/deactivating climate con-
trol
General notes
When the climate control is switched off, the air
supply and air circulation are also switched off.
The windows could fog up. Therefore, switch off
climate control only briefly
i
Activate climate control primarily using the
à button (
Y page 120).
Activating/deactivating
X
Turn the SmartKey to position 2 in the ignition
lock (
Y page 127).
X
To activate: press the à button.
The indicator lamp in the à button lights
up. Airflow and air distribution are set to auto-
matic mode.
X
To deactivate: press the ^ button.
The indicator lamp in the ^ button lights
up.
Operating the climate control systems
119
Climate control