Operation Manual

Engine
Display messages
Possible causes/consequences and M Solutions
+
Check Coolant Level
See Operator's Man‐
ual
The coolant level is too low.
!
Avoid making long journeys with too little coolant in the engine
cooling system. The engine will otherwise be damaged.
X
Add coolant, observing the warning notes before doing so
(
Y page 276).
X
If you need to add coolant more often than usual, have the engine
coolant system checked at a qualified specialist workshop.
?
The fan motor is faulty.
X
At coolant temperatures below 248 ‡(120 †), drive to the nearest
qualified specialist workshop.
X
Avoid subjecting the engine to heavy loads, e.g. driving in moun-
tainous terrain, and stop-and-go traffic.
?
Coolant Too Hot
Stop Vehicle Turn
Engine Off
The coolant is too hot.
A warning tone also sounds.
G
WARNING
Do not drive when your engine is overheated. This can cause some
fluids which may have leaked into the engine compartment to catch
fire.
Steam from the overheated engine can also cause serious burns which
can occur just by opening the hood.
There is a risk of injury.
X
Pull over and stop the vehicle safely and switch off the engine, pay-
ing attention to road and traffic conditions.
X
Secure the vehicle against rolling away (Y page 146).
X
Wait until the engine has cooled down.
X
Make sure that the air supply to the engine radiator is not blocked,
e.g. by snow, slush or ice.
X
Do not start the engine again until the display message goes out and
the coolant temperature is below 248 (120 †). Otherwise, the
engine could be damaged.
X
Pay attention to the coolant temperature display.
X
If the temperature increases again, visit a qualified specialist work-
shop immediately.
Under normal operating conditions and with the specified coolant
level, the coolant temperature may rise to 248 (120 †).
222
Display messages
On-board computer and displays