Operation Manual

Display messages
Possible causes/consequences and M Solutions
¨
Stop Vehicle Vehi‐
cle Too Low
You have pulled away while the vehicle level is still too low.
AIRMATIC sets the vehicle to the selected level after a short period.
X
Pull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
X
Secure the vehicle against rolling away (Y page 146).
X
Wait until the display message disappears before pulling away.
AIRMATIC is defective. A warning tone also sounds.
X
Do not drive at speeds above 50 mph (80 km/h).
X
Make only slight steering movements. Otherwise, the front fender
or the tires could be damaged if the steering movement is too large.
X
Listen for scraping sounds.
X
Pull over and stop the vehicle safely, paying attention to road and
traffic conditions, and set a higher vehicle level.
Depending on the malfunction, it may be possible to raise the vehi-
cle.
X
Visit a qualified specialist workshop.
¨
Malfunction
The AIRMATIC function is restricted. The vehicle's handling charac-
teristics may be affected.
X
Do not drive at speeds above 50 mph (80 km/h).
X
Visit a qualified specialist workshop.
Traffic Sign Assist
Currently Unavaila‐
ble See Operator's
Manual
Traffic Sign Assist is temporarily inoperative.
Possible causes are:
R
the windshield in the camera's field of vision is dirty.
R
visibility is impaired due to heavy rain, snow or fog.
X
Clean the windshield.
If the system detects that the camera is fully operational, the display
message disappears.
Traffic Sign Assist is operational again.
Traffic Sign Assist
Inoperative
Traffic Sign Assist is faulty.
X
Visit a qualified specialist workshop.
ë
Off
The HOLD function is deactivated. The vehicle is skidding.
A warning tone also sounds.
X
Reactivate the HOLD function later (Y page 164).
Display messages
225
On-board computer and displays
Z