Operation Manual

ManualsBrandsMercedes ManualsCarCLS 2016

271

272

273

274

275

276

277

278

279

280

When indicator lamp : flashes green: pro-

gramming was successful. The next step is to

synchronize the rolling code (

Y page 271).

Release button B on remote control A for

the garage door drive system.

If indicator lamp : lights up red: repeat the

programing procedure for the corresponding

button on the rear-view mirror. When doing

so, vary the distance between remote control

A and the rear-view mirror.

The required distance between remote con-

trol A and the integrated garage door opener

depends on the garage door drive system.

Several attempts might be necessary. You

should test every position for at least

25 seconds before trying another position.

Synchronizing the rolling code

Pay attention to the "Important safety notes"

(

Y page 270).

If the garage door system uses a rolling code,

you will also have to synchronize the garage

door system with the integrated garage door

opener in the rear-view mirror. To do this you will

need to use the programming button on the door

drive control panel. The programming button

may be located in different places depending on

the manufacturer. It is usually located on the

door drive unit on the garage ceiling.

Familiarize yourself with the garage door drive

operating instructions, e.g. under "Program-

ming additional remote controls", before carry-

ing out the following steps.

Your vehicle must be within reach of the garage

door or gate opener drive. Make sure that nei-

ther your vehicle nor any persons/objects are

present within the sweep of the door or gate.

Turn the SmartKey to position 2 in the ignition

lock (

Y page 127).

Get out of the vehicle.

Press the programming button on the door

drive unit.

Usually, you now have 30 seconds to initiate

the next step.

Get into the vehicle.

Press previously programmed button ;, =

or ? on the integrated garage door opener

repeatedly and in quick succession until the

door closes.

The rolling code synchronization is then com-

plete.

Notes on programming the remote con-

trol

Canadian radio frequency laws require a "break"

(or interruption) of the transmission signals

after broadcast

ing for a few seconds. Therefore,

these signals may not last long enough for the

integrated garage door opener. The signal is not

recognized during programming. Comparable

with Canadian law, some U.S. garage door open-

ers also feature a "break".

Proceed as follows:

if you live in Canada

if you have difficulties programming the

garage door opener (regardless of where you

live) when using the programming steps

Press and hold one of buttons ; to ? on the

integrated garage door opener.

After a short time, indicator lamp : lights up

yellow.

Release the button.

Indicator lamp : flashes yellow.

Press button B of garage door remote con-

trol A for two seconds, then release it for two

seconds.

Press button B again for two seconds.

Repeat this sequence on button B of remote

control A until indicator lamp : lights up

green.

When indicator lamp : lights up green: pro-

gramming is finished.

When indicator lamp : flashes green: pro-

gramming was successful. The next step is to

synchronize the rolling code.

Release button B of remote control A of the

garage door drive.