Operation Manual

the SmartKey and the corresponding door han-
dle should not be greater than 3 ft (1 m).
X
Touch recessed sensor surface : on the
door handle until the side windows and the
sliding sunroof are fully closed.
X
Touch recessed sensor surface : on the
door handle until the side windows are fully
closed.
i
Make sure you only touch recessed sensor
surface :.
X
Make sure that all the side windows and the
sliding sunroof are closed.
X
Make sure that all the side windows are
closed.
X
To interrupt convenience closing: release
recessed sensor surface : on the door han-
dle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
X
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
ignition lock.
X
Pull the corresponding switch on the door
control panel until the side window is com-
pletely closed (
Y page 87).
X
Hold the switch for an additional second.
If the side window opens again slightly:
X
Immediately pull the corresponding switch on
the door control panel until the side window is
completely closed (
Y page 87).
X
Hold the switch for an additional second.
X
If the respective side window remains closed
after the button is released, then it has been
set correctly. If this is not the case, repeat the
steps above again.
Side windows
89
Opening and closing
Z