Operation Manual

t
Where do you want to save: home or
work?
s
Work
t
The destination has been saved.
“Find Address”
You can use the “Find address” command to
select a previously saved address and start
route guidance. Say the name of an address
exactly as you have entered it into the
address book, e.g. if you entered first name
and last name, you have to say both.
Example of dialog:
s
Find address
t
Please say the name
s
Smith
u
The system shows a numbered list of
saved addresses in the display. If there
is only one entry on the list, voice
control asks if it is correct.
t
Please select a line number or say the
name
s
Number 1
t
Number 1 accepted, Smith work
t
Starting route guidance
“Start Route Guidance”
When Route Guidance is inactive, you can use
the “Start route guidance” command to start
route guidance once a valid destination has
been entered.
s
Start route guidance
t
Starting route guidance
“Route Information”
You can use the “Route information”
command to have the following information
on your currently planned route read out:
R
Distance to destination/stopover
R
Expected arrival time
R
Remaining driving time
“Guidance Instructions On”
When you use the “Guidance instructions on”
command, voice control repeats the last
driving tip. If the driving tip output has been
switched off up to this point, it is now
switched on again.
“Guidance Instructions Off”
You can use this command to switch off the
route guidance voice output.
“Cancel Route Guidance”
You can use this command to stop route
guidance.
Example of dialog:
s
Cancel route guidance
t
Are you sure you want to cancel route
guidance?
s
Yes
t
Canceling route guidance
Voice control cancels route guidance.
or
s
No
t
Continuing route guidance.
The dialog with voice control is terminated.
Route guidance remains activated.
“Zoom In”/“Zoom Out”
You can use these commands to zoom the
map display one step in or out.
“Zoom In Completely”/“Zoom Out
Completely”
You can use these commands to set the map
display directly to the smallest or largest
scale.
“List Destination Memory”
You can use the “List destination memory”
command to listen to the entries from the
address book’s destination memory and, if
required, navigate to one of them. If the list
190
Navigation
Voice Control