Operation Manual

Text reader settings
Setting the read-aloud speed
X
Press the W button.
X
Select Settings using
the :=; buttons and press the
9 button to confirm.
X
Select Text Reader Speed and press the
9 button to confirm.
Alist appears. The # dot indicates the
current setting.
X
Selectasetting using the 9:
buttons and press the 9 button to confirm.
Voice Control System settings
General notes
This function is available if COMAND features
an integrated hard disk.
To protect the integrated hard disk, COMAND
deactivates it at very high temperatures and
at extreme altitudes. The Voice Control
System will then be temporarily unavailable.
Opening/closing the help window
X
Press the W button.
X
Select Settings using
the :=; buttons and press the
9 button to confirm.
X
Select Voice Control and press the 9
button to confirm.
X
Select Help window and press the 9
button to confirm.
You have switched the help window on
O or off ª.
i
The help window provides information in
addition to the audible instructions during
individualization as well as later, when you
are using voice control.
Individualization
Introduction
Using individualization, you can fine tune the
Voice Control System to your own voice and
thus improve voice recognition. This means
that other users' voices will not be recognized
as easily, and therefore this function can be
deactivated (Y page 39).
Individualization comprises two parts and
takes approximately 5minutes. It consists of
training the system to recognize a certain
number of digit sequences and voice
commands.
Starting new individualization
Individualization can only be started when the
vehicle is stationary. Before starting, switch
off all devices or functions which could
interfere, such as the radio or the navigation
system. After starting the session, the system
guides you through the training with spoken
instructions.
X
Press the W button.
X
Select Settings
using
the :=; buttons and press the
9 button to confirm.
X
Select Voice Control and press the 9
button to confirm.
X
Select Start new individualization
and press the 9 button to confirm.
You will see and hear a prompt, asking
whether you would like further information.
X
Select Yes or No and press the 9 button
to confirm.
If you select No
, the first part of
individualization begins. You will be asked
whether you would like to train digits or
voice commands.
If you select Yes
, you will see and hear
information on the individualization
38
Voice Control System settings
System settings